Gable Trim Installation

1. Install tacky tape to the bottom of the 1” flat on the gable trim the entire length.

2. Starting at the eave, attach gable trim flashing to roofing panel with #9 x 1 1/2” woodgrip

fastener every 16”.

3. Overlap gable trim flashing a minimum of 3”.

4. Allow gable trim to overhang eave by 1” so gable trim can be folded down to give gable trim a

finished look.

* Purlin placement should be approximately 1” from the gable end running parallel with it.

RECOMMENDED ACCESSORIES                                  

Tacky Tape (1 roll = 50’ of coverage)